Maintain Your Floor

K Guard +

Karndean’s surface protection system, K Guard +, uses PU technology to ensure that there is no need to apply an additional surface treatment following installation. It also works as a barrier against scuff marks, stains and fine scratches.

Applying a new coating of K Guard +

Depending on how heavily the floor is used, if at any time there is a need to revitalize the floor this can be done using Karndean's K Guard + specialized floor coating.

Apply Karndean's coating by following these steps:

• Vacuum, sweep or dry mop to remove all dust and loose debris
• Use the Karndean stripper (diluted as applicable) to strip off all grease and ingrained dirt
• Rinse the floor well
• Apply 2 to 3 thin coats of Refresh allowing each coating to be fully dry before the next coat is applied
• Do a routine maintenance cleaning