Flooring Adhesive

We recommend that you use our range of Karndean Designflooring adhesives. There are five that we hold in stock for you to order.

Karndean Universal Adhesive

Our Universal Adhesive is suitable for most applications. It is brand new resin-free, wet-bed high-temperature dispersion adhesive, designed specifically for Luxury Vinyl Tile floor coverings.

It is:

  • Solvent-free and odourless throughout installation
  • Good shear resistance
  • Good working time
  • Good grab
  • Reduces open joints or peaking from Designflooring tiles and planks

And is suitable for:

  • Heavy wear use areas in domestic and commercial locations
  • Where castor chairs are used (EN 12 529)
  • Level, absorbent, sound surfaces
  • Underfloor heating systems

Available in both 5 litre and 15 litre tubs it is available in stock for order with your Designflooring products.

Pressure Sensitive Adhesive

Ideal for use in most residential and commercial installations. Best used as semi-dry/tack. Once adhesive has reached the semi-dry tack condition you will have approximately 2 hours working time.

High Temperature Adhesive

A modified acrylic adhesive with an improved service temperature. For use in areas subject to excessive heat and direct sunlight e.g. conservatories, shop windows, patio doors, external panelled doors and under floor heating. Dry fit floor in sections. Remove dry flooring including cuts.

Apply High Temperature adhesive  in smooth consistent sweeps being careful not to leave puddles or streaks. Place flooring into wet adhesive. Apply hand roller over newly bonded floor. Wipe any excess adhesive off flooring immediately with a clean damp cloth.

We always recommend that you work section by section, as product must be laid in wet adhesive. When using this adhesive the open time is approximately 15 minutes, depending on atmospheric conditions.


Epoxy Resin Adhesive

Epoxy Resin is a two-part mix. Both components should be mixed together with a drill and paddle to a smooth consistency and the contents poured out within 5 minutes of mixing time. If left within the container the resin will harden inside 15 minutes; on the floor you have up to 1 hour working time.

Recommended for areas subject to moisture and high temperature. Any areas under question consult your supplier.

Eye protection and gloves must be worn when using this product.

Acrylic Adhesive

Ideal for use in most normal residential and commercial installations. We always recommend that you work section by section, as product must be wet bonded when installed with this adhesive. The open time is approximately 15 minutes, depending on atmospheric conditions.

Using the correct tools

When using our adhesives in to important to use an A2 adhesive trowel. These are available from Karndean directly and most flooring supply outlets.

Extreme Heat

If you are using Karndean Designflooring in areas that may be subject to extremely excessive direct heat, 50°C or above, which may include:

  • Shop windows
  • South facing conservatories
  • Orangeries
The floor must be installed with Epoxy Resin adhesive. It is particularly necessary to keep the temperature in conservatories at a constant 18°-26° prior to, during, and for 24 hours after installation. It would also be advisable to shade windows to ensure that constant temperature conditions are maintained for 48 hours after installation.